How much plant do you build for an uncertain feed?
Choose a reliable measurement floor and an illustrative design factor. Watch the design basis change, then test what happens when equipment comes in fixed sizes.
Enlarge for bigger labels, then swipe sideways →
5.0% × 2.0 = 10.0% design basis under this invented rule. With continuous sizing, capacity is 100% of the original 10% basis. The 4.9% sample is below the chosen quantitation floor; being below it does not establish zero contamination.
What this model assumes
Every number is illustrative. We choose design basis (%) = quantitation floor (%) × chosen factor, and capacity proportional to this load. A factor of two is not a standard or a justified design decision for a real plant. The original comparison is a 5% floor with factor 2, giving 10%; relative capacity always uses that fixed 10% baseline. Discrete mode rounds capacity upward in fictional 2-percentage-point steps. A quantitation floor is the lowest amount reliably quantified; a lower amount may still be detected. It is not a standard uncertainty or a hard threshold at which all signals disappear. JCGM guard bands involve measurement uncertainty and decision risk; they do not derive this invented floor-times-factor rule. Flow variation, kinetics, fouling, turndown, equipment cost curves, sensor cost and operating options are omitted.
Better measurements can change a design basis; the margin still needs engineering judgment.
A result below a quantitation limit cannot be quantified with the required precision and accuracy. It may still be detected. Calling it zero would lose information; it also does not mean every low sample produces exactly the same sensor signal.
For this invented example, choose a design basis equal to the quantitation floor multiplied by a chosen factor. A 5% floor and factor 2 give 10%. A 2% floor with the same factor gives 4%. With capacity directly proportional to this load, that is 40% of the original capacity, a 60% reduction.
The factor and proportional sizing rule are teaching choices. NASA describes margins as allowances for uncertainties and risks. JCGM describes decision guard bands using measurement uncertainty and risk; a quantitation limit is a different quantity. Neither source prescribes multiplying a sensor floor by two to size a process.
Real decisions also depend on flow variation, kinetics, fouling, turndown and operating strategy. Equipment comes in discrete sizes and its cost need not scale with capacity. The optional 2-point size steps here are fictional.
Under this lesson’s chosen rule, an 8% floor and factor 1.5 give what basis, and what if the floor improves to 4%?
Taking a real process
beyond the lab?
Jon and I are building RARE Labs toward an autonomous pilot plant builder using AI and robotics. Join the waitlist for updates, and tell us what you’re trying to scale.
Go a little deeper.
- NASA · Systems Engineering HandbookAppendix B: margin ↗
General definition of margin as an allowance for uncertainty and risk; no process sizing factor is prescribed.
- JCGM 106:2012 · section 8.3.2Measurement uncertainty in conformity assessment ↗
Guard bands use uncertainty and a decision rule; they do not derive this example’s sizing formula.
- ICH Q2(R1) · historical glossaryDetection and quantitation limits ↗
Definitions used for this explanation. Q2(R1) is a historical guideline, not presented as current validation guidance.