Why does one plastic snap while another folds?

Change temperature and composition, then bend a model sample. Separate glass transition from melting.

Teaching model
Polymer chain mobility, retained crystal anchors and an interactive bending samplePolystyrene20 °C · Tg ≈ 100 °CMolecular-scale viewSegment motion is restrictedBend the samplePress “Bend sample” or move the sliderChain size and deformation are schematic.

Enlarge for bigger labels, then swipe sideways →

Illustrative Tg99.9 °C
Temperature minus Tg-79.9 °C
Crystal anchorsNot modeled

At 20 °C, the sample is below its illustrative Tg (99.9 °C), giving restricted segment mobility. Use the bend control to compare the qualitative response.

What this model assumes

Representative Tg values are about 100 °C for polystyrene and −125 °C for polyethylene. Actual values depend on grade and measurement conditions. Polyethylene retains crystalline regions above Tg; the display uses an illustrative 130 °C melting threshold, not a universal melting point. The blend uses the Fox equation in kelvin, 1/Tg = w1/Tg1 + w2/Tg2, with illustrative pure-component values 373 K and 200 K. It assumes a miscible blend and is not a formulation recipe. Chain motion, bending and brittle fracture are qualitative teaching responses, not stress, strain, modulus or fracture predictions. Real response also depends on loading rate, crystallinity, thermal history and additives.

Segment mobility changes how a plastic bends.

Glass transition concerns the amorphous parts of a polymer. Below the transition, large-scale segment movement is restricted. Above it, segments can rearrange more readily under stress. A whole chain need not drift through the sample.

Polystyrene has a glass transition near 100°C. Polyethylene’s is much colder; the reference table lists about −125°C for HDPE. Polyethylene can still be solid above that transition because its crystalline regions have not melted. The table lists an HDPE melting point near 130°C; these rounded values do not identify a particular bag or cup.

The blend uses the Fox relation, 1/Tg = (1−w)/Tg,polymer + w/Tg,additive, with every temperature in kelvin and w a mass fraction. The illustrative inputs 373 K and 200 K give about 318 K, or 45°C, at 20% additive.

The bend picture illustrates greater or smaller flexibility; it cannot predict a fracture or a safe hot-water test. Thickness, material formulation, thermal history, loading rate and the measurement method matter. Real transitions occur over a range, and the simple blend relation does not cover every mixture.

Why can polyethylene fold at room temperature while remaining solid?

Taking a real process
beyond the lab?

Jon and I are building RARE Labs toward an autonomous pilot plant builder using AI and robotics. Join the waitlist for updates, and tell us what you’re trying to scale.

Join the RARE Labs waitlist ↗

Go a little deeper.