Food + rheology / INTERACTIVE LESSON 12

Why does ketchup wait, then rush?

Separate two ideas: the stress needed to start flow and what happens once it flows.

CHANGE A CONDITION. SEE WHAT FOLLOWS.

Teaching model
Herschel–Bulkley yield and shear-thinning modelPush past the yield stressτ = τy + Kγ̇ⁿ · flowing branchShear stress, τ (Pa)0357002550Shear rate, γ̇ (s⁻¹)FLOWING

Enlarge for bigger labels, then swipe sideways →

Applied shear stress20 Pa
Steady shear rate2.531 s⁻¹
Apparent viscosity7.9 Pa·s

At 20 Pa, the model gives 2.531 s⁻¹ and an apparent viscosity of 7.9 Pa·s. Here n < 1 describes a shear-thinning flowing branch: the apparent viscosity falls as shear rate rises. Yield stress and the post-yield flow response are different properties.

What this model assumes

An ideal steady Herschel–Bulkley fluid with illustrative parameters: τ = τy + Kγ̇ⁿ on the flowing branch. Below or at τy, this idealization has zero steady shear rate; it does not model elastic deformation or slow creep. K has units Pa·sⁿ, γ̇ has s⁻¹, and apparent viscosity τ/γ̇ has Pa·s. This is not a fit to a ketchup brand and excludes time-dependent thixotropy.

SEPARATE THE TWO IDEAS

Can it shear-thin with no yield stress?

Yes. Fix the yield stress at zero, then change how fast you deform the material. This isolates rate dependence from the threshold in the first experiment.

Shear thinning without a yield thresholdApparent viscosity (Pa·s)010200.1110100Shear rate (s⁻¹) · logarithmic spacing

Illustrative model curves, not a measurement of any bottle.

Apparent viscosity2.13 Pa·s
Required shear stress21.29 Pa

Increase the shear rate and watch the apparent viscosity fall.

Equation, assumptions and a useful distinction

Here τy = 0, K = 6 Pa·sⁿ, τ = Kγ̇ⁿ and ηapp = τ/γ̇ = Kγ̇ⁿ⁻¹. The numerical K is held at 6 for each illustrative n; its units depend on n. The comparison is anchored at 1 s⁻¹. Shear thinning does not mean stress decreases as rate rises. A fluid can also have a yield stress with a linear post-yield response (a Bingham model). Neither model captures time-dependent thixotropy, creep, temperature effects or a particular recipe. Yielding is not a thermodynamic solid-to-liquid phase change.

THE IDEA TO TAKE WITH YOU

A fluid can resist flow at first and become easier to deform after it yields.

A yield-stress model has a threshold below which there is no steady shear flow.

A shear-thinning material has decreasing apparent viscosity as shear rate increases. This is different from the existence of a yield threshold.

The Herschel–Bulkley equation combines both ideas. The parameters here are illustrative, not measurements of a particular ketchup.

QUICK CHECK

Are yield stress and shear thinning the same property?

FROM UNDERSTANDING TO BUILDING

Taking a real process
beyond the lab?

Jon and I are building RARE Labs toward an autonomous pilot plant builder. Join the waitlist for updates, and tell us what you’re trying to scale.

Join the RARE Labs waitlist ↗

FOLLOW THE EVIDENCE

Go a little deeper.